iPad 2 Wi-Fi EMC 2415 Volume and Power Button Cable Replacement 20 No'lu Adım Geçmişi

20. Adımdaki Değişiklikler

Düzenleyen: Jason L — 24 Oca 2015

Düzenleme onaylandı tarafından Andrew Optimus Goldheart

	[* icon_note] To remove the upper component board you will be pulling gently on its cable while lifting it up enough to clear the battery, but not high enough to scrape against the rear case. Go slowly and carefully.
	[* black] Insert the tip of a spudger under the upper component board to lift it slightly.
	[* black] Pull the board up and out of the space between the battery and the rear case bezel.
	[* black] Remove the upper component board.
-	[* icon_reminder] On reassembly, you'll want to reconnect the GPS antenna cable at this point. Use tweezers and work carefully.
+	[* icon_reminder] On reassembly, you'll want to reconnect the GPS antenna cable at this point. Use tweezers and work carefully. On reassembly, insert and thread the screw removed in step 45 without tightening. Tighten after all upper component board screws are inserted and threaded. This is easier before the component board glue sets.