Ana içeriğe geç

12. Adımdaki Değişiklikler

Düzenleyen: Joshua

Düzenlenme reddedildi tarafından David Hodson

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[* red] Use a small flathead screwdriver to remove the 4.8 mm standoff near the headphone jack.
[* icon_note] When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.
[* black] When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.
[* blackorange] When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place. Without this partThis piece protects the motherboard could damagedigitizer cable and the LCD cable from the edge of the ribbon cables around itlogic board.
[* blackorange] When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place. Without this partThis piece protects the motherboard could damagedigitizer cable and the LCD cable from the edge of the ribbon cables around itlogic board.

Resim 1

Eski Sürüm

Yeni Sürüm