Ana içeriğe geç

12. Adımdaki Değişiklikler

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[* red] Use a small flathead screwdriver to removeRemove the 4.8 mm standoff screw near the headphone jack.
[* icon_note] Standoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* red] Use a small flathead screwdriver to removeRemove the 4.8 mm standoff screw near the headphone jack.
[* icon_note] Standoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* icon_note] When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.
[* icon_reminder] When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.
[* icon_reminder] When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place.
[* orange] Without this part, the motherboard could damage the ribbon cables around it.