3. Adımdaki Değişiklikler
Düzenleyen: Lawrence Zhu —
Düzenleme onaylandı tarafından Lawrence Zhu
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* red] Locate the fan connector, 2-pin JST type (see picture), from the extruder board on the top of the extruder assembly. |
|---|---|
| - | [* black] Gently lift the fan. |
| - | [* icon_note] The fan should easily fall out |
| + | [* red] Locate the fan connector, a 2-pin JST type, from the extruder board on the top of the extruder assembly and while firmly holding the plastic part of the connector, wiggle out the wire. |
| + | [* black] Gently lift the fan off and away from the module. The fan should easily fall out. |