Ana içeriğe geç

1. Adımdaki Değişiklikler

Düzenleyen: ihab taha

Düzenleme onaylandı tarafından ihab taha

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[title] Remove Crank Shaft Position Sensor
[* red] Lay under the car and locate the crank shaft position sensor.
[* icon_caution] Make sure the car has not been used in a couple hours. If it has been used recently its parts will still be hot.
[* black] Use the 10mm wrench to loosen the 10mm Hex Head bolt attaching the crankshaft position sensor to the car.
[* black] Use the 10mm wrench to loosen the 10mm Hex Head bolt attaching the crankshaft position sensor to the car.
[* icon_note] Note the correct position of the sensor so you will be able to insert the new sensor later on.
[* black] After you have removed the 10mm Hex Head bolt on the sensor pull the sensor out of place with some force. (it should pop right out)
[* black] After you have removed the 10mm Hex Head bolt on the sensor pull the sensor out of place with some force. (it should pop right out)