UP! Plus 2 Spool Holder Replacement 2 No'lu Adım Geçmişi

2. Adımdaki Değişiklikler

Düzenleyen: Brian Greenberg — 8 Kas 2014

Düzenleme onaylandı tarafından Brian Greenberg

	[title] Remove plastic filaments
-	[* red] ~~Withdraw~~ the plastic filament from the extrusion assembly
-	[* icon_note] Cut off ~~excess~~ plastic ~~hanging~~ from the
-	[* black] Remove the filament tube
-	[* black] Remove the spool from the spool holder by lifting it up and taking it ~~out~~
+	[* red] Go to "Maintenance" and tell the printer to withdraw the plastic filament from the extrusion assembly. Finish removing the filament by pulling upwards.
+	[* icon_note] Cut off any damaged plastic from the end of the filament.
+	[* black] Remove the filament tube.
+	[* black] Remove the spool from the spool holder by lifting it up and taking it off.