5. Adımdaki Değişiklikler
Düzenleyen: Christopher Kovey —
Düzenleme onaylandı tarafından Christopher Kovey
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] Replacing purge bulb | |
| [* red] Loosen the two screws holding on the carburetor with a T27 Torx bit turning it counter clockwise. | |
| [* icon_note] The pictures show the airfilter housing removed. This is not necessary or recommended and only done to take better pictures. | |
| + | [* icon_note] Be sure not to lose or tear the gasket between the carburetor and the intake manifold. It will need to be replaced if either occurs |
| [* orange] Remove the four screws holding on the old purge bulb by turning counter clockwise. | |
| [* black] Remove plate holding on purge bulb. | |
| - | [* black] Old purge bulb should come right out and replace it with the new. |
| + | [* black] Old purge bulb should come right out and replace it with the new. Be sure the rim of the new purge valve is properly seated when reinstalling |