Echo SRM-225 Trimmer Fuel Lines Replacement 5 No'lu Adım Geçmişi

5. Adımdaki Değişiklikler

Düzenleyen: Christopher Kovey — 2 Ara 2021

Düzenleme onaylandı tarafından Christopher Kovey

	[title] Replacing purge bulb
	[* red] Loosen the two screws holding on the carburetor with a T27 Torx bit turning it counter clockwise.
	[* icon_note] The pictures show the air filter and filter housing removed
	[* icon_caution] Be sure not to lose or tear the gasket between the carburetor and the intake manifold. It will need to be replaced if either occurs
	[* orange] Remove the four screws holding on the old purge bulb by turning counter clockwise.
	[* yellow] Remove plate holding on purge bulb.
	[* green] The old purge bulb should come right out and replace it with the new. Be sure the rim of the new purge valve is properly seated when reinstalling
	[* light_blue] Reinstall the purge bulb plate and securely tighten the four screws. Be sure not to overtighten these screws as they can easily strip
+	[* blue] Now reinstall the air filter housing, carburetor, and gasket in the same manner they were removed. Finally, reinstall the air filter and air housing cover.