Daisy Model 10 Carbine Cocking Lever Replacement 1 No'lu Adım Geçmişi

1. Adımdaki Değişiklikler

Düzenleyen: Trelawney Bullis — 10 Kas 2014

Düzenleme onaylandı tarafından Trelawney Bullis

+	[title] Removing Screws
+	[* black] Place the carbine with the saddle ring and leather thong facing upwards
+	[* black] Locate the three screw heads.
+	[* icon_note] There should be one on either side of the saddle ring and one on the cocking lever assembly.
+	[* black] Place your less dominant hand on the underside of the cocking lever, making sure your hand is located directly below the washers, and grasp firmly on the underside of the carbine.
+	[* black] Place a #2 Phillips Screwdriver in the screw on the cocking lever assembly. Twist with a counter-clockwise motion.
+	[* black] Completely remove the screws.
+	[* icon_caution] Be wary of the black washer that should now be in your less-dominant hand. Note: the screw should be 11/16ths of an inch and matte black.