Ana içeriğe geç

2. Adımdaki Değişiklikler

Düzenleyen: Andrew Bookholt

Onay bekleniyor


Adım Satırları

[* black] While holding the plastic retainer down against the board, use the tip of a spudger to pry the PRAM battery out if its housing.
[* icon_caution] Failure to hold the plastic retainer down during the prying process may result in it tearing off the logic board.
[* icon_reminder] Before installing the heat sink onto the logic board, it is essential to apply a new layer of thermal paste. [guide|744|This] guide will show you how to do it.