Ana içeriğe geç

13. Adımdaki Değişiklikler

Düzenleyen: Nick

Düzenleme onaylandı tarafından Nick

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Clean off any residual contact cleaner
-[* black] After spraying the switch, wipe the board if any got on the PCB. After you do this, reassemble the receiver and let it dry for at least 30 mintues before plugging it back in.
-[* icon_reminder] If you choose to clip the zipties on the fan, replace them during reassembly. If you do not do this they will land in the fan and kick the receiver into protection mode. Tucking them behind the fan can work, but it is not recommended.
-[* icon_note] There is only one correct fix for this. A replacement board. This should not be used as a long term fix and is not a good solution to sell as a professional repair. You can use this to see if the unit can be repaired if you want, which is probably the more ideal use for this fix.
+[* black] If any contact cleaner got on the board, wipe it off before reassembling the unit. Once the board is dry, start reassembling the unit. Let the unit dry for 30 minutes before using it again, just to be safe.
+[* icon_reminder] If you cut the zipties on the fan for easy board access, these will need to be replaced. If you do not do this, the cables may get trapped in the fan and kick it into protection mode. You may be able to tuck them in the fan grooves, but this is not a good idea.
+[* icon_note] The only reliable long term fix is a replacement board. This may work for years, but it may also only last a few months, or not at all. Your mileage will vary on how long this fixes the unit.