Ana içeriğe geç

13. Adımdaki Değişiklikler

Düzenleyen: Nick

Düzenleme onaylandı tarafından Nick

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[title] Clean off any residual contact cleaner
-[* black] If any contact cleaner got on the board, wipe it off before reassembling the unit. Once the board is dry, start reassembling the unit. Let the unit dry for 30 minutes before using it again, just to be safe.
-[* icon_reminder] If you cut the zipties on the fan for easy board access, these will need to be replaced. If you do not do this, the cables may get trapped in the fan and kick it into protection mode. You may be able to tuck them in the fan grooves, but this is not a good idea.
-[* icon_note] The only reliable long term fix is a replacement board. This may work for years, but it may also only last a few months, or not at all. Your mileage will vary on how long this fixes the unit.
+[title] Wipe away any excess contact cleaner
+[* icon_caution] The only reliable long term fix for this problem is a replacement board. The reason for this is there is no way to tell if your board will keep working for years or fail again.
+[* icon_caution] While you can reassemble the unit right away, it should not be plugged in for ~30 minutes-1 hour. This will allow any leftover contact cleaner to dry.
+[* icon_reminder] If you cut the ziptie, now is the perfect time to replace it. Reassemble the unit in a way the wires will not get stuck in the fan and ziptie them back where they used to be. Failure to do this may result in protection mode problems. ***Tip: If you do not have zipties, try tucking the wires behind the fan in a way they will not fall loose.***
+[* black] If any contact cleaner got on the board, wipe it off before reassembling the unit. Once this is dried up as well as you can, wait on reassembly or begin reassembling the unit now.