Ana içeriğe geç

13. Adımdaki Değişiklikler

Düzenleyen: Nick

Düzenleme onaylandı tarafından Nick

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Wipe away any excess contact cleaner
[* icon_caution] The only reliable long term fix for this problem is a replacement board. The reason for this is there is no way to tell if your board will keep working for years or fail again.
[* icon_caution] While you can reassemble the unit right away, it should not be plugged in for ~30 minutes-1 hour. This will allow any leftover contact cleaner to dry.
-[* icon_reminder] If you cut the ziptie, now is the perfect time to replace it. Reassemble the unit in a way the wires will not get stuck in the fan and ziptie them back where they used to be. Failure to do this may result in protection mode problems. ***Tip: If you do not have zipties, try tucking the wires behind the fan in a way they will not fall loose.***
-[* black] If any contact cleaner got on the board, wipe it off before reassembling the unit. Once this is dried up as well as you can, wait on reassembly or begin reassembling the unit now.
+[* icon_reminder] If you cut the ziptie, put a new one on when the faceplate is reinstalled on the receiver. If you do not have one available, the wires can be tucked behind the fan in a way they won't easily fall out and jam the fan. ***Note:*** Failure to do this may result in protection mode problems. If this happens the wires should be ziptied to avoid problems.
+[* black] If any contact cleaner got on the board, wipe it off before reassembling the unit. Once this is dry, reassemble the receiver.