Ana içeriğe geç

9. Adımdaki Değişiklikler

Düzenleyen: Nick

Düzenleme onaylandı tarafından Nick

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Unclip the faceplate
-[* black] Remove the faceplate. Push on both tabs and push forward. The faceplate will tilt forward, as shown in the pictures.
-[* icon_note] If you are finding the constraints to be limited in this state, you can clip the zip ties used by the factory on the fan. If you do this, make sure you replace the zip ties or the cables will eventually get caught in the fan and go into protection mode because it cannot run the cooling fan.
+[* icon_reminder] If you are still constrained for work space, disconnect the ziptie from the fan. ***IMPORTANT: If this ziptie is cut, it should be replaced to avoid false protection mode problems, should the wires get stuck in the cooling fan.***
+[* black] With the faceplate loose and all of the cables disconnected, remove the faceplate from the receiver. While you can do this one side at a time, pushing both in at the same time is easier. Once this is done, the faceplate should tilt forward as shown in the 2nd picture.