Ana içeriğe geç

9. Adımdaki Değişiklikler

Düzenleyen: Nick

Düzenleme onaylandı tarafından Nick

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Unclip the faceplate
-[* black] Cut both zipties that hold the front panel wires on the fan. These must be cut to free the front panel enough to give you access to the front panel boards. ***Note: These zipties must be replaced in order to avoid problems with the receiver going into protection mode.***
-[* black] With the faceplate loose and all of the cables disconnected, unclip the faceplate. Once it is disconnected, lay the faceplate of the receiver on your work space. ***Tip:*** While one clip can be released at one time, it is possible to release both at once.
+[* icon_reminder] Once the unit is reassembled, these zipties must be replaced. Failure to do this may result in protection mode errors.
+[* black] Cut the zipties that hold the front panel wires on the fan. This is required as it is the best way to free up room on the front panel to access the control boards.
+[* black] With the faceplate loose and all of the cables disconnected, unclip the faceplate one side at a time. The faceplate should lay on your workspace with enough room to work on accessing the control boards.