6. Adımdaki Değişiklikler
Düzenleyen: Cole Lindemulder —
Düzenlenme reddedildi tarafından Nick Schultz
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* icon_note] This step is performed with the motherboard out of the chassis. |
|---|---|
| + | [* icon_note] When removing the Heatsink from your Console Motherboard and reinstalling it properly, keep your old screws. But if they're lost or you got rid of them, if the replacement screws threads are small enough, they'll suffice as replacements. |
| + | [* icon_caution] Since the CPU and GPU DIEs are exposed, they are more fragile than a ordinary PC Processor. !!!Do not overtighten the Heatsinks unless you want to risk your console CPU and GPU!!! |
| [* black] Insert a machine screw through each of the four holes around the CPU heat sink, with their heads on the back side of the board. | |
| [* black] While holding the head of the screw, place a nylon washer ***then*** a metal washer over the threads. | |
| [* icon_caution] The order of the washers is important. ***Do not*** put the metal washer on first. | |
| [* icon_caution] When attaching the CPU heat sink, be sure the fins are aligned with the air flow from the fans (as seen in the third picture). Having the flat side of the fins perpendicular to the air flow will cause your Xbox 360 to overheat. | |
| - | [* red] Using the large flathead screwdriver bit, tighten the screws into the CPU heat sink. First lightly tighten the four screws in an X-shaped pattern as seen in the second picture, then follow the same X-shaped sequence to really torque the screws down. |
| - | [* icon_note] Don't be afraid of over-tightening the screws - the pressure between the heat sinks and processors caused by sufficiently torqued screws is needed to squeeze the processors back against the board. |
| - | [* icon_reminder] Repeat the same process to attach your GPU heat sink. |
| + | [* icon_reminder] When you secure the GPU Heatsink, be sure to apply even pressure to prevent damage to the DIE, and once you tighten the Heatsink, do not overtighten it as, again, you will run the risk of damages that're nearly impossible to fix without the proper supplies and documentation. |
| + | [* icon_note] When installing the screws into the GPU Heatsink, follow the same steps as done for the CPU to ensure as much of a Proper fit. |