Xbox 360 Red Ring of Death Fix Kit 6 No'lu Adım Geçmişi - iFixit

6. Adımdaki Değişiklikler

Düzenleyen: Cole Lindemulder — 2 Mar 2025

Düzenleme onaylandı tarafından Arthur Shi

: Önce
: Sonra
: Değiştirilmemiş

Adım Satırları

	[* icon_note] This step is performed with the motherboard out of the chassis.
-	[* black] Insert a machine screw through each of the four holes around the CPU heat sink, with their heads on the back side of the board.
-	[* black] While holding the head of the screw, place a nylon washer *then* a metal washer over the threads.
+	[* black] Insert a machine screw through each of the four holes around the CPU heat sink, with their heads on the back side of the board. While you hold the screws in place, *Sandwich the Nylon Washer between the Motherboard and Metal Washer.*
	[* icon_caution] The order of the washers is important. *Do not* put the metal washer on first.
	[* icon_caution] When attaching the CPU heat sink, be sure the fins are aligned with the air flow from the fans (as seen in the third picture). Having the flat side of the fins perpendicular to the air flow will cause your Xbox 360 to overheat.
-	[* red] Using the large flathead screwdriver bit, tighten the screws into the CPU heat sink. First lightly tighten the four screws in an X-shaped pattern as seen in the second picture, then follow the same X-shaped sequence to really torque the screws down.
-	[* icon_note] Don't be afraid of over-tightening the screws - the pressure between the heat sinks and processors caused by sufficiently torqued screws is needed to squeeze the processors back against the board.
+	[* red] Using the large flathead screwdriver bit, tighten the screws into the CPU heat sink. First lightly tighten the four screws in an X-shaped pattern as seen in the second picture, then follow the same X-shaped sequence to fasten the screws down.
+	[* icon_note] Don't be afraid of a bit of tension - the pressure between the heat sinks and processors caused by sufficiently tightened screws is needed to retain the Heatsinks.
+	[* icon_caution] If you tighten the screws too much, I hope you're ready to risk your 360's CPU and GPU, or even cause damage to your Motherboard. *Processor (CPU and GPU) DIEs are quite fragile by themselves. With too much pressure on either mount, that can be enough to cause your system Irreparable damage on one or both of the console DIEs.*
	[* icon_reminder] Repeat the same process to attach your GPU heat sink.