Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

3. Adımdaki Değişiklikler

Düzenleyen: Tyler Scholz

Düzenleme onaylandı tarafından Tyler Scholz

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] First, Unscrew the six Phillips J1 screws that are holding down the fan and heat sink down. Thenwith a Magnetized Jewelry Phillips #1 screwdriver. Then use Philipsa Phillips #1 to remove the single screw near the bottom of the heat sink.
[* red] Six Silver Chrome 5.8mm screws
[* orange] One 5.8mm Screw
[* icon_caution] Remove the four screws that are holding down the CPU (the four to the top left that form a rectangle in this image) first. Unscrew them in an X pattern (eg. top left screw, bottom right screw, top leftright screw, bottom rightleft screw) to minimize risk of harming CPU.
[* black] First, Unscrew the six Phillips J1 screws that are holding down the fan and heat sink down. Thenwith a Magnetized Jewelry Phillips #1 screwdriver. Then use Philipsa Phillips #1 to remove the single screw near the bottom of the heat sink.
[* red] Six Silver Chrome 5.8mm screws
[* orange] One 5.8mm Screw
[* icon_caution] Remove the four screws that are holding down the CPU (the four to the top left that form a rectangle in this image) first. Unscrew them in an X pattern (eg. top left screw, bottom right screw, top leftright screw, bottom rightleft screw) to minimize risk of harming CPU.