Ana içeriğe geç

5. Adımdaki Değişiklikler

Düzenleyen: Sam Goldheart

Düzenleme onaylandı tarafından Sam Goldheart

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* red] Use the flat end of a spudger or your fingernail to carefully flip up the retaining flap for each ribbon cable ZIF socket.
-[* blue] When disconnecting the ZIF socket lift from the center (blue) outwards to the edge of the board/towards the cables respectively.
+[* red] Use the flat end of a spudger or your fingernail to carefully flip up both retaining flaps one each of the ZIF sockets.
+ [* icon_note] When disconnecting the ZIF sockets flip them outwards to the edge of the board/towards the cables respectively.
[* icon_caution] Be careful not to damage the pin connector. Pull parallel to the device, not up.
[* icon_note] For more info on how to disconnect ZIF connectors, check out the [guide|25629|Recognizing & Disconnecting Cable Connectors guide|stepid=64969|new_window=true].

Resim 2

Eski Sürüm

Yeni Sürüm