Ana içeriğe geç

4. Adımdaki Değişiklikler

Düzenleyen: Tim Spellings

Düzenleme onaylandı tarafından Tim Spellings

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* icon_reminder] Line up the pedal with its socket and begin to turn it in the correct tightening direction that was specified at the beginning of the guide.
+[* black] Line up the pedal with its socket and begin to turn it in the correct tightening direction that was specified at the beginning of the guide.
[* icon_note] Placement of the wrenches for tightening can be found in the picture and are consistent with the directions from step 2.
[* red] This is the regular wrench holding on to the pedal's securing hex-nut.
[* yellow] This is the Allen wrench in the bolt socket.
-[* black] Once the pedal is partially secured from the initial rotations, use your wrench to continue tightening.
+[* green] Once the pedal is partially secured from the initial rotations, use your wrench to continue tightening.
[* icon_reminder] Each pedal has different directions for tightening which were noted previously in step 1.
[* black] Once resistance is felt, you will want to turn the pedal about 1/8 of a rotation more for proper tightness.
[* icon_caution] Do not crank on the wrench to tighten the pedal further. This can lead to a stuck pedal in the future.

Resim 1

Eski Sürüm

Yeni Sürüm