Ana içeriğe geç

4. Adımdaki Değişiklikler

Düzenleyen: John Lasseter

Düzenleme onaylandı tarafından John Lasseter

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Line up the pedal with its socket and begin to turn it in the correct tightening direction that was specified at the beginning of the guide.
[* icon_note] Placement of the wrenches for tightening can be found in the picture and are consistent with the directions from step 2.
- [* red] This is the regular wrench holding on to the pedal's securing hex-nut.
- [* yellow] This is the Allen wrench in the bolt socket.
-[* green] Once the pedal is partially secured from the initial rotations, use your wrench to continue tightening.
- [* icon_reminder] Each pedal has different directions for tightening which were noted previously in step 1.
+[* black] Once the pedal is partially secured from the initial rotations, use your wrench to continue tightening.
+ [* icon_note] For tightening, the right pedal must be turned clockwise and the left pedal must be turned counter-clockwise. Opposite of Step 2
[* black] Once resistance is felt, you will want to turn the pedal about 1/8 of a rotation more for proper tightness.
[* icon_caution] Do not crank on the wrench to tighten the pedal further. This can lead to a stuck pedal in the future.

Resim 1

Eski Sürüm

Yeni Sürüm