Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

6. Adımdaki Değişiklikler

Düzenleyen: Jonathan Fish

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] fine tune the derailleur Using the barrel adjuster screw located where the cable and cable housing meet the derailleur.
[* black] shift through each gear while pedaling. the derailleur should move one gear every time you shift up or down on the shifter.
[* blackicon_note] if the chain skips or makes noise when not shifting, Use the barrel adjustment screw to position the guide sprocket so it is right under the gear that corresponds to what number the shifter displays.
[* blackicon_note] Loosening the barrel adjuster screw will effectively pullpulls in the cablecable, causing the derailleur to move slightly totowards a larger gear and vis-versagear. Tightening causes the derailler to move towards a smaller gear.
[* black] Repeat the previous stepsteps until the derailleur shifts smoothly and makes a minimal amount of noise.
[* blackicon_note] if the chain skips or makes noise when not shifting, Use the barrel adjustment screw to position the guide sprocket so it is right under the gear that corresponds to what number the shifter displays.
[* blackicon_note] Loosening the barrel adjuster screw will effectively pullpulls in the cablecable, causing the derailleur to move slightly totowards a larger gear and vis-versagear. Tightening causes the derailler to move towards a smaller gear.
[* black] Repeat the previous stepsteps until the derailleur shifts smoothly and makes a minimal amount of noise.