Ana içeriğe geç

3. Adımdaki Değişiklikler

Düzenleyen: Alex Sireci

Düzenleme onaylandı tarafından Alex Sireci

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Insert New LED
-[* black] Place the new LED through the holes where the old one was
- [* black] If it does not stay, you can tape it in place on the opposite side of the board
- [* black] Ensure the LED is on the same side of the board as the one you removed was
+[* black] Place the new LED through the open holes
+ [* red] The LED should cover the schematic symbol on the circuit board and the flat edge of the LED should line up with the tip of the diode symbol shown by the arrow
+ [* black] If the LED does not stay, you can tape it in place on the opposite side of the board
[* black] Warm up the trace on the circuit board and the LED lead with the soldering iron
[* icon_reminder] Wipe your soldering iron on the damp sponge every time you pick it up
-[* black] Apply solder to the lead until the hole is filled with solder
+[* black] Apply solder to the lead until the hole completely fills with solder

Resim 2

Önceki resim yok

Eklendi