3. Adımdaki Değişiklikler
Düzenleyen: Alex Sireci —
Düzenleme onaylandı tarafından Alex Sireci
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Insert New LED |
|---|---|
| + | [* black] Place the new LED through the open holes |
| + | [* red] The LED should cover the schematic symbol on the circuit board and the flat edge of the LED should line up with the tip of the diode symbol shown by the arrow |
| + | [* black] If the LED does not stay, you can tape it in place on the opposite side of the board |
| + | [* black] Warm up the trace on the circuit board and the LED lead with the soldering iron |
| + | [* icon_reminder] Wipe your soldering iron on the damp sponge every time you pick it up |
| + | [* black] Apply solder to the lead until the hole completely fills with solder |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi