Disassembling 1989-1992 Ford Ranger Front suspension 4 No'lu Adım Geçmişi - iFixit

4. Adımdaki Değişiklikler

Düzenleyen: Andrew walker — 16 Oca 2016

Düzenleme onaylandı tarafından Andrew walker

: Önce
: Sonra
: Değiştirilmemiş

Adım Satırları

+	[* black] Now that the hub have been cleaned and old bearings have been removed you can now begin with the rotors.
+	[* black] Start by wiping the inside of the rotors with a clean rag it is not necessary to clean every spec off grease out the inside of the rotors make sure no dirt or peaces of metal are left behind you can also use a flat head screwdriver to expose racers there will be one in the front and one in the back of roters.
+	[* black] Now you have located racers tap them out evenly so they won't get stuck once they are removed wipe again so the area will be ready for the new racers.
+	[* black] Now you are ready for the new racers to be installed make sure to tap them in evenly as well so that insures they will seat all the way down.
+	[* black] Now you are ready to install new bearings on the shaft make sure to pack grease evenly on bearings to insure longer lasting life with new bearings no reason to have to go back anytime soon to do this job again.
+	[* black] Insert inner bearing first making sure tapered side is facing you now place outer bearing on shaft making sure the tapered side is facing you now place roter over bearings then washer now slightly thread bolt on the shaft to hold assembly in place if need be evenly tap bearing with socket to seat a tight fit making sure not to damage bearing.
+	[* black] once roter is seated snug on the shaft tighten bolt slid bolt lock over bolt then place pin fill cap with grease then put cap back over hardwear repeat proses on other side.
+	[* black] Before you do the other side make there is little to no play with roter shake side to side top bottom left right to insure the roter seats all the way down also don't over tighten bolt check toque specs if u are unsure of how tight the bolt needs to be if it were me i would make snug then quarter turn is good enough for me but its your ride.