Eşyalarını Tamir Et Topluluk Mağaza

1. Adımdaki Değişiklikler

Düzenleyen: Ron Davis —

Düzenleme onaylandı tarafından Ron Davis

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] Begin by using a heat gun or the iOpener (this will take longer) to melt the adhesive all around the outer edge of the screen.
+[* black] Begin by using a heat gun or the iOpener (This will take longer.) to melt the adhesive all around the outer edge of the screen.
[* icon_caution] Avoid holding the heat gun too close to the Microsoft Surface 2 so as to not cause any unwanted warping.
-[* icon_caution] Avoid touching the metal end of the gun because it will be very hot and can burn you.
+[* icon_caution] Avoid touching the metal end of the gun. It will be very hot and can burn you.
[* black] Insert the opening picks just under the screen and black edging. Be sure to place them evenly on each side.
-[* black] Using the gap created from the guitar picks, slowly pry the screen from the body of the Microsoft Surface 2 with the help of any plastic prying tool. Pry as uniformly as possible.
+[* black] Using the gap created by the picks, slowly pry the screen from the body of the Microsoft Surface 2 with a plastic opening tool. Pry as uniformly as possible.