Eşyalarını Tamir Et Topluluk Mağaza

6. Adımdaki Değişiklikler

Düzenleyen: Andrew Bookholt —

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total).
[* icon_caution] You'll install the rest in a bit.
-[* icon_note] When you tighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.
+[* icon_note] Tighten the screws, then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.