Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Bu Adımdaki Değişiklikler

Düzenleyen: Evan Noronha

Düzenleme onaylandı tarafından Evan Noronha

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Insert a fourth plasticBefore beginning this step, ensure the battery connector is adequately folded out of the way so the card alongdoesn't sever it.
[* icon_caution] This step needs to '''completed precisely as shown.''' Any variation from
the other edge ofprescribed procedure '''will''' result in logic board damage.
[* icon_caution] As you are pushing
the iPad withcard underneath the edge ofbattery, ensure it does not push against any logic board components. It should slide over them easily. If the card extending pastpushes against the edge of any components, remove it and slide the rear case. Be sure to insertfirst plastic card (inserted in step 33) towards the logic board so it offers more support.
[* black] Insert a fourth plastic
card '''belowsuch that the battery and'''left edge is above the logic board''', as shown infirst card you inserted''', and the photo'''right edge overlaps the edge of the rear case'''.
[* black] Insert a fourth plasticBefore beginning this step, ensure the battery connector is adequately folded out of the way so the card alongdoesn't sever it.
[* icon_caution] This step needs to '''completed precisely as shown.''' Any variation from
the other edge ofprescribed procedure '''will''' result in logic board damage.
[* icon_caution] As you are pushing
the iPad withcard underneath the edge ofbattery, ensure it does not push against any logic board components. It should slide over them easily. If the card extending pastpushes against the edge of any components, remove it and slide the rear case. Be sure to insertfirst plastic card (inserted in step 33) towards the logic board so it offers more support.
[* black] Insert a fourth plastic
card '''belowsuch that the battery and'''left edge is above the logic board''', as shown infirst card you inserted''', and the photo'''right edge overlaps the edge of the rear case'''.
[* icon_caution] Insert the card below the battery connector and do not press the card laterally against any logic board components.
[* black] Press the card underneath the battery until it overlaps the large EMI shield on the logic board.

Resim 1

Eski Sürüm

Yeni Sürüm

Resim 2

Eski Sürüm

Yeni Sürüm