Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Bu Adımdaki Değişiklikler

Düzenleyen: Sam Goldheart

Düzenleme onaylandı tarafından Sam Goldheart

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Before beginning this step, ensure the battery connector is adequately folded out of the way so the card doesn't sever it.
[* icon_caution] This step needs to '''completed precisely as shown.''' Any variation from the prescribed procedure '''will''' result in logic board damage.
[* icon_caution] As you are pushing the card underneath the battery, ensure it does not push against any logic board components. It should slide over them easily. If the card pushes against the edge of any components, remove it and slide the first plastic card (inserted in step 33) towards the logic board so it offers more support.
[* icon_caution] As you are pushing the card underneath the battery, ensure it does not push against any logic board components. It should slide over them easily. If the card pushes against the edge of any components, remove it and slide the first plastic card (inserted in step 33) towards the logic board so it offers more support.
[* black] Insert a fourth plastic card such that the '''left edge is above the first card you inserted''', and the '''right edge overlaps the edge of the rear case'''.
[* icon_caution] Insert the card below the battery connector and do not press the card laterally against any logic board components.
[* black] Press the card underneath the battery until it overlaps the large EMI shield on the logic board.