Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

9. Adımdaki Değişiklikler

Düzenleyen: Luke Soules

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Use a 1.5 mm hex bitT6 Torx screwdriver to install two of the set screws on the side of the hard drive closest to the end of the hard drive cable that attaches to the logic board.
[* icon_caution] Be sure you are installing them on the correct side of the hard drive.
[* black] Use a 1.5 mm hex bitT6 Torx screwdriver to install two of the set screws on the side of the hard drive closest to the end of the hard drive cable that attaches to the logic board.
[* icon_caution] Be sure you are installing them on the correct side of the hard drive.
[* black] Tighten the screws until they contact the end of the threaded holes in the side of the hard drive. They are shown correctly installed in the third picture.