30. Adımdaki Değişiklikler
Düzenleyen: Phillip Takahashi —
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* black] Secure the PCB to the case half that had the old power supply unit using the original screw and the included washer. |
|---|---|
| + | [* icon_caution] Do not over-tighten the screw or you will break the screw hole. |
| + | [* icon_note] Be sure to orient the PCB so that it lines up with the indentation of the case and the voltage regulator is pointed towards the indentation |
| + | [* black] Peel the backing off the heat sink. |
| + | [* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is shifted so that the corner pointing at the screw lines up with the voltage regulator. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi