Eşyalarını Tamir Et Topluluk Mağaza

30. Adımdaki Değişiklikler

Düzenleyen: Phillip Takahashi —

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] Secure the PCB to the case half that had the old power supply unit using the original screw and the included washer.
+[* black] Secure the PCB to the upper case half using the original screw and the included washer.
[* icon_caution] Do not over-tighten the screw or you will break the screw hole.
- [* icon_note] Be sure to orient the PCB so that it lines up with the indentation of the case and the voltage regulator is pointed towards the indentation
+ [* icon_note] Be sure to orient the PCB so that the voltage regulator points towards where the grey power inlet used to be.
[* black] Peel the backing off the heat sink.
-[* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is shifted so that the corner pointing at the screw lines up with the voltage regulator.
+[* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is set so that it lines up with the inside edge of the voltage regulator as seen in the third picture.