Eşyalarını Tamir Et Topluluk Mağaza

34. Adımdaki Değişiklikler

Düzenleyen: Phillip Takahashi —

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] Give the beads a few seconds to cool and then remove them and mash them together.
- [* icon_caution] The beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads.
-[* black] Stretch glob of plastic into a thin strip that will fill one of the gaps between the case halves.
+[* black] Give the plastic beads a few seconds to cool and then remove them and mash them together until they are one piece.
+ [* icon_caution] The plastic beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads.
+[* black] Stretch the glob of plastic into a thin strip that will fill one of the gaps between the case halves.
[* black] Press the plastic into the crevices and smooth it out with your finger.
- [* black] If the plastic becomes too hard to work with, you can re-apply heat to loosen the plastic.
+ [* icon_note] If the plastic becomes too hard to work with, you can re-apply heat to loosen the plastic.
[* icon_caution] Be cautious if you reheat the plastic while it's in the case. Allow cooling periods between reheating so you don't accidentally de-solder any components.