Eşyalarını Tamir Et Topluluk Mağaza

4. Adımdaki Değişiklikler

Düzenleyen: Madison Touchton —

Düzenleme onaylandı tarafından Madison Touchton

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Peel off a few feet of the adhesive backing on the roll of new bar tape.
[* black] Affix the center of the end of the tape with the edge of the drop bar so that half of the width of the tape hangs over the end of the bar.
[* black] Begin to snugly wrap the tape up the handlebar, pulling the tape up and over the handlebar toward the bicycle.
- [* black] As you wrap, peel off more adhesive backing as needed and overlap each new layer of tape by one half of its width.
+ [* icon_note] As you wrap, peel off more adhesive backing as needed and overlap each new layer of tape by one half of its width.
[* icon_note] When wrapping the tape around curves in the handlebars, allow for more overlap on the inside of the curve and less overlap on the outside of the curve.