Ana içeriğe geç

7. Adımdaki Değişiklikler

Düzenleyen: Ron Davis

Düzenleme onaylandı tarafından Ron Davis

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* orange] Undo hard drive ribbon by lifting black clips upward.
-[* red] Undo screws (4.6 mm) holding hard drive in place
-[* black] There may be only one screw of these screws, the one at bottom right. The upper position screw may already have been removed (The 4th red circle from the left in step 4)
+[* orange] Flip up the retaining flaps on each end of the I/O board ribbon cable ZIF connector.
+[* black] Carefully pull the the I/O board ribbon cable from its sockets.
+[* red] Remove the two 4.6 mm screws holding the hard drive in place.