Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

2. Adımdaki Değişiklikler

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* icon_caution] Be careful when pullingblack] Heat the glass screen offperimeter of the phone because there is a connector which connectsdisplay using an iOpener, hair dryer, or heat gun.
[* icon_note] Heat will help soften
the screenadhesive securing the display, making it easier to the phone. This connector willseparate. The display should be removed separately in the next step.
[* icon_note] It may be necessary
heated until it's slightly too hot to heat the glass paneltouch, for roughly two minutes. Use extra caution if working with a heat gun or hair dryer to softengun, as applying too much heat will permanently damage the adhesiveOLED panel.
[* black] Carefully pryUse a suction cup to lift one edge of the screen just slightly, creating a small gap between the front display assembly offand the phone by sliding a plasticframe of the phone.
[* black] Insert an
opening toolpick into the gap.
[* black] Carefully slide the opening pick
around the seamperimeter of the device.
[*
phone to separate the adhesive.
[* icon_caution] If you plan to re-use the display, don't insert the opening pick more than a few millimeters into the phone, or you may damage the OLED panel underneath the glass.
[*
icon_note] UseYou may need to slide the suction cuppick around the perimeter multiple times to pullfully separate the screen off if it will notadhesive. Work slowly and carefully until the display begins to come off withfree.
[* black] Gently lift
the opening tooldisplay, but don't try to fully detach it yet—it is still connected by a ribbon cable lying underneath.
[* icon_caution] Be careful when pullingblack] Heat the glass screen offperimeter of the phone because there is a connector which connectsdisplay using an iOpener, hair dryer, or heat gun.
[* icon_note] Heat will help soften
the screenadhesive securing the display, making it easier to the phone. This connector willseparate. The display should be removed separately in the next step.
[* icon_note] It may be necessary
heated until it's slightly too hot to heat the glass paneltouch, for roughly two minutes. Use extra caution if working with a heat gun or hair dryer to softengun, as applying too much heat will permanently damage the adhesiveOLED panel.
[* black] Carefully pryUse a suction cup to lift one edge of the screen just slightly, creating a small gap between the front display assembly offand the phone by sliding a plasticframe of the phone.
[* black] Insert an
opening toolpick into the gap.
[* black] Carefully slide the opening pick
around the seamperimeter of the device.
[*
phone to separate the adhesive.
[* icon_caution] If you plan to re-use the display, don't insert the opening pick more than a few millimeters into the phone, or you may damage the OLED panel underneath the glass.
[*
icon_note] UseYou may need to slide the suction cuppick around the perimeter multiple times to pullfully separate the screen off if it will notadhesive. Work slowly and carefully until the display begins to come off withfree.
[* black] Gently lift
the opening tooldisplay, but don't try to fully detach it yet—it is still connected by a ribbon cable lying underneath.

Resim 1

Eski Sürüm

Yeni Sürüm

Resim 2

Eski Sürüm

Yeni Sürüm

Resim 3

Önceki resim yok

Eklendi