Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

6. Adımdaki Değişiklikler

Düzenleyen: Arthur Shi

Düzenleme onaylandı tarafından Arthur Shi

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* red] Disconnectblack] Flip the battery by using a spudger to pry up the battery connectorphone over.
[* icon_note] A large daughterboard interconnect cable coversblack] Push an opening pick slowly and firmly down the battery. Before removingright edge of the battery, you will needbattery (which should be warm). Slide it slightly back and forth to detach thisslice through the adhesive.
[* icon_caution] Be careful not to snag the white antenna
cable and move it outrunning along the edge of the way.
[* orange] Peel back
battery while you are push down on the tape coveringpick.
[* icon_note] If you are having a hard time getting
the lower end ofopening pick under the cable to reveal where it connectsbattery, heat and re-apply an iOpener as instructed in the previous step.
[* icon_note] You can also apply some high concentration isopropyl alcohol
to the daughterboard. Then, use your spudgeredge in order to pry uphelp weaken the cable and disconnect itadhesive.
[* black] If desired,Once you can dohave loosened the same at the top endright side of the cablebattery from the case, leave an opening pick in place to detach and remove it completely, or you may simply bend the cable gently out of the way while you removeprevent the batteryadhesive from re-adhering.
[* red] Disconnectblack] Flip the battery by using a spudger to pry up the battery connectorphone over.
[* icon_note] A large daughterboard interconnect cable coversblack] Push an opening pick slowly and firmly down the battery. Before removingright edge of the battery, you will needbattery (which should be warm). Slide it slightly back and forth to detach thisslice through the adhesive.
[* icon_caution] Be careful not to snag the white antenna
cable and move it outrunning along the edge of the way.
[* orange] Peel back
battery while you are push down on the tape coveringpick.
[* icon_note] If you are having a hard time getting
the lower end ofopening pick under the cable to reveal where it connectsbattery, heat and re-apply an iOpener as instructed in the previous step.
[* icon_note] You can also apply some high concentration isopropyl alcohol
to the daughterboard. Then, use your spudgeredge in order to pry uphelp weaken the cable and disconnect itadhesive.
[* black] If desired,Once you can dohave loosened the same at the top endright side of the cablebattery from the case, leave an opening pick in place to detach and remove it completely, or you may simply bend the cable gently out of the way while you removeprevent the batteryadhesive from re-adhering.

Resim 1

Eski Sürüm

Yeni Sürüm

Resim 2

Eski Sürüm

Yeni Sürüm

Resim 3

Önceki resim yok

Eklendi