iMac Intel 17" Display Replacement 5 No'lu Adım Geçmişi

5. Adımdaki Değişiklikler

Düzenleyen: Hon Lee — 30 Eyl 2010

	[* icon_reminder] Allow the EMI shield to hang down from the display.
	[* red] Remove the four coarse-thread T10 Torx screws securing the display to the rear case.
	[* icon_note] These screws are recessed, so a thin screwdriver such as [product\|IF145-014\|this] is essential for removal. Bit drivers tend to be too short for this application.
-	[* icon_note] It is ~~helpful~~ to use a magnetized screwdriver so the screws won't fall into the iMac.
+	[* icon_note] It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac. Note: when screws fall into the iMac, it's really difficult to get it out!!