Eşyalarını Tamir Et Topluluk Mağaza

1. Adımdaki Değişiklikler

Düzenleyen: Asa Zernik —

Düzenlenme reddedildi tarafından Adam O'Camb

Önce
Sonra
Değiştirilmemiş

Adım Satırları

+[title] Cut screen adhesive
[* black] Turn off the device.
[* black] [guide|11677|Prepare an iOpener] and lay it along one edge of the display for about 90 seconds to soften the adhesive underneath. Alternatively, you may use a heat gun or hair dryer to heat the adhesive.
[* black] Use a suction cup to pull up on the display and create a slight gap between the display and the phone's enclosure.
[* icon_note] If your display is cracked, [guide|103487|cover it with packing tape|stepid=193572|new_window=true] to help the suction cup adhere and to prevent glass shards from popping loose.
-[* icon_caution] The display panel is fragile. If you plan to re-use your display, take care to insert your tool only as far as necessary to separate the adhesive. Inserting the tool any further will damage the display. To minimize the risk of damage, you can use the edges of playing cards to separate the adhesive, rather than a plastic tool.
-[* black] Insert an opening pick or other thin tool into the gap.
-[* black] Slide the opening pick around the perimeter of the display, slicing through the adhesive that secures it.
+[* black] Insert an opening pick shallowly into the gap - 1mm or less.
+ [* icon_caution] The display panel is fragile. If you plan to re-use your display, take care to insert your tool only as far as necessary to separate the adhesive. Inserting the tool any further will damage the display. To minimize the risk of damage, you can use the edges of playing cards to separate the adhesive, rather than a plastic tool.
+[* black] Slide the opening pick around the perimeter of the display, slicing through the adhesive that secures it. The adhesive does not extend under the screen itself - it forms a frame 1mm thick on the sides, 1cm thick on the bottom, and 1.5cm thick on top.