3. Adımdaki Değişiklikler
Düzenleyen: johnsawyercjs —
Düzenleme onaylandı tarafından Alex Diaz-Kokaisl
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] Use the tip of a spudger to flip up the retaining flap on the left fan ribbon cable ZIF socket. |
|---|---|
| + | [* black] Use the tip of a spudger to flip up the retaining flap on the left fan ribbon cable ZIF socket. This flap is tiny, thin, and very delicate, so be very careful when lifting it--don't force it. |
| [* icon_caution] Be sure you are prying up on the hinged retaining flap, ***not*** the socket itself. | |
| - | [* black] Starting at the top of the cable, slide a plastic opening tool under the left fan cable to free |
| - | [* icon_caution] Use caution when freeing the cable, as it |
| + | [* black] Starting at the top of the cable, slide a plastic opening tool under the left fan cable to free its adhesive from the logic board. |
| + | [* icon_caution] Use caution when freeing the cable, as it may be strongly adhered to the logic board. If necessary, use an iOpener or hair dryer to heat the cable in order to soften the adhesive and make it easier to remove. |
| [* black] Lift the left fan out of the device. | |
| + | [* black] While the fan is removed, inspect its outlet and its blades for dust, and if there is any, remove it using a can of compressed air and a soft brush. |
| [* icon_reminder] When reinstalling the fan, it's easiest to connect the fan ribbon cable as you drop the fan in place, rather than after you've installed the three fan screws. |