| - | [* red] Use tweezers and a soldering iron to remove the black and red wires from the motherboard. This will release the vibration motor from the controller assembly. |
|---|
| - | [* icon_reminder] The vibration motors are different from each other so it is necessary to mark which motor comes from each side. Take note where the red and black wires attach because it is important that they are attached the same way as the original. |
|---|
| + | [* black] Mark each motor according to the side it attaches. The rumble motors are different so they will not work if you switch them. |
|---|
| + | [* icon_reminder] Take note where the red and black wires attach because they should be attached the same way as the original. |
|---|
| + | [* icon_note] Use the [guide|750|Soldering Iron Guide] to help you with removing and attaching the wires. |
|---|
| + | [* red] Use tweezers and a soldering iron to remove the black and red wires from the motherboard. This will release the rumble motor from the controller assembly. |
|---|