Ana içeriğe geç
Yardım
Adım 7 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Make sure ONLY the larger plug is connected to the Circuit Board; we will connect the smaller one later to make it easier.

Then make sure all the Spring are lined up correctly and seated in there spots.

Press down on the Circuit Board until the board meets the cover and the Screw Holes are aligned with one another.

Make sure that the springs are still in alignment.

Then with one hand, place your screws in and tighten them.

Be sure to stop the moment they get tight you don't want to crack the board.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.