Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Yardım
Adım 2 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Remove top cap of sander. Carefully loosen motor brushes, they pop out by hand. Inspect for excessive wear (worn to coming close to spring).

During assembly, if the carbon contact block/brush itself has popped out at any time, when refitting, make sure the curvature of the brush fits the rotor nicely to avoid excessive wear.

When assembling, make sure the brushes are out, or they will block the rotor from moving up into the bearing housing.

Remove the body by loosening the 4 torx screws in the base and carefully lifting the body off.

From now on you need to be careful and avoid damage to any of the wiring or contacts. So in the next phase, where you have to get rough, be careful!!

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.