Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı


Adım 7 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

grease, something compatible with rubber. I used silicone grease. This also helps keeping them in place when beating it back together in the next steps.

Dampers' groove go into the little slot.

Hold upside down, base plate one quarter turn from body. Put the 4 dampner assemblies in. Caps groove seem to fit best when it points to the long sides of the sander.

The flat side should fit below the little standing ledge. Some did not go down into the body in certain positions.

Keep holding upside down, align. Place on piece of wood. Put piece of wood on top center. Smack it. Check the dampers are still in place. Align, repeat till bearing is flush with shaft again. Sander plate should be free from body.

Smack with pieces of wood. Check every hit to see if they do not jump out.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.