Ana içeriğe geç
Adım 5 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Let’s replace with a new inductor and see how it works.

Remove black adhesive around first. Then apply some medium-temp solder paste to the bonding pad. Tin the bonding pad with solder paste with the help of the Soldering Iron at 365℃. Once done, clean with PCB Cleaner.

Continue to apply some rosin to the bonding pad. We can see that the damaged inductor is really small. And the replacement inductor is difficult to find.

We can solder a zero-ohm resistor instead. Get a zero-ohm resistor in the right position. Solder with Hot Air Gun at 330℃, air flow 1. Clean with PCB Cleaner afterwards.

Again, let’s run diode mode measurement of Pin 8 on the infrared camera connector. The measured value is 257, which is normal.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.