Ana içeriğe geç
Yardım

Logitech MX Master Side Feet Removal

Adım 1 Düzenleniyor —

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 4kılavuzları etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Flip the mouse's power switch into the OFF position, unplug any cables, and flip it over so the feet are facing up.

The unique shape of some mice can prevent them from laying flat. If you need to, lay your mouse on a soft towel to prevent wobble.

If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.

Apply a heated iOpener to the left and right mouse feet for about one minute each.

Alternatively, you can use a hair dryer to soften the mouse feet adhesive.

When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case.

The information sticker adhesive may soften during this step, but you don't need to remove it.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.