Ana içeriğe geç
Yardım

Motherboard Disconnection

Adım 4 Düzenleniyor —

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 2kılavuzları etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Grip the power button cable close to the head and pull it away from its ZIF connector slowly and steadily to separate the coating.

If the coating feels stubborn, reheat the connector and try again.

Keep pulling on the cable until it comes completely out of its socket.

During reassembly:

Inspect the head of the cable and the ZIF connector for any remaining coating that could prevent a good connection.

Peel off the coating—heating the cable and the ZIF connector when the coating becomes too brittle.

It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in its connector.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.