Ana içeriğe geç
Yardım

Kobo Clara Colour Power Button Board Replacement

Adım 3 Düzenleniyor —

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 4kılavuzları etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Use blunt nose tweezers to grip the cable close to the head and pull it away from its ZIF connector slowly and steadily to separate the coating.

If the coating feels stubborn, reheat the connector and try again.

Gripping the tweezers closer to the tip can help you get a tighter hold on the cable.

Keep pulling on the cable until the cable comes completely out of its socket.

During reassembly:

Inspect the head of the cable and the ZIF connector for any remaining coating that could prevent a good connection.

Peel off the coating—heating the cable and the ZIF connector when the coating becomes too brittle.

It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in its connector.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.