Ana içeriğe geç
Yardım
Adım 1 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

FIRST IMAGE: Remove the power supply. Align the kettle as shown, with the handle to your right. Use the 7/32" nut driver to remove the 7/32" nut from the stud that is located clockwise from where the power supply was attached.

Use tweezers to remove the split-ring lock washer located under the nut.

SECOND IMAGE: Roll the kettle over so the handle is now on your left. Use the 7/32" nut driver to remove the 7/32" nut from the final stud, which is now located counter-clockwise from where the power supply was attached.

Use tweezers to remove the split-ring lock washer located under the nut.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.