Ana içeriğe geç
Yardım
Adım 14 Düzenleniyor —

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Now support the speedometer gauge face and the rest of the assembly on something soft that will protect it. Some foam was used in this case.

Then, using a hammer and small punch, tap out the shaft shown in the last step from the side with the small brass ring.

Press your finger against the gear end to keep the shaft from falling out. This shaft also acts to support the numbers. Without it they "droop" down and can also become out of alignment.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.